INCH-POUND
MIL-DTL-1734J
30 January, 2002
SUPERSEDING
MIL-S-1734H
6 December, 1984
DETAILED SPECIFICATION
SLIPS, TENT LINE
This specification is approved for use by all Departments and Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope. This specification covers two types of tent line slips.
1.2 Classification. (see 6.2).
Type I - Flat, quick release
Type II - Casting
APPLICABLE DOCUMENTS
2.
*2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to ensure
the completeness of this list, document users are cautioned that they must meet all specified
requirements documents cited in sections 3 and 4 of this specification, whether or not they are listed.
2.2
Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise
Beneficial comments (recommendations, additions, deletions, clarifications) and any pertinent
data which may be of use in improving this document should be addressed to: Defense Supply
Center Philadelphia, Clothing and Textiles Directorate, Attn: DSCP-CNR, 700 Robbins Ave.,
Philadelphia, PA 19111-5096 by using the Standardization Document Improvement Proposal
(DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 8340
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business