MIL-DTL-43176D
TABLE I. End item visual defects (continued)
Classification
Examine
Defect
Major
Minor
A
B
Stitching
Less than specified:
Margin
- for more than 2 inches but not more than 4
inches in length
318
- for more than 4 inches in length
222
Stitching
Chain portion of stitching shows on outside
indicated
of screen or cover
223
by "Z"on
drawings
Mends,
Repairs not in accordance with Department of the
darns or
Army Field Manual FM 10-16 or not authorized
patches
by the contracting officer (see 3.4)
111
Components Any component or part omitted, not assembled or
& assembly
fabricated of applicable reference material
112
Hems
Constructed with partial turnunder when double
turnunder is required
319
Twisted or pleated
320
Reinforce-
Improperly applied, causing excessive fullness on
ments
reinforcement or reinforced parts
321
Cementing,
Puckers, loose edges, unadhered pocket
general
or tunnels
224
Excess adhesion resulting in sags or
lumps evident through outer layer of fabric
225
Adhesive exposed beyond the overcoated
area on interior surface
322
General
Any other construction detail not performed
as specified
226
Marking &
labels
Omitted, incorrect, illegible, or misplaced
323
Cleanness
Grease or oil stains
324
Thread ends not trimmed to ½ inch or less
325
------------------------------------------------------------------------------------------------------------------
*4.4.4 End item dimensional examination. The end item shall be examined for
conformance to the specified dimensions. Any dimension not within the specified tolerance shall
be classified as a defect. The lot size shall be expressed in units of shields. The sample unit shall
be one shield. The inspection level shall be S-3.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business