INCH-POUND
MIL-DTL-43002E
14 September, 2000
---------------------
SUPERSEDING
MIL-S-43002D
6 February, 1984
DETAILED SPECIFICATION
SHIELD, STOVEPIPE, TENT, NONMETALLIC
This specification is approved for use by all Departments and Agencies of the Department of
Defense.
1.
SCOPE
1.1 Scope. This specification covers requirements for a flexible, silicone rubber coated
shield for a tent stovepipe opening.
APPLICABLE DOCUMENTS
2.
*2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
2.2
Government documents.
*2.2.1 Specifications, standards, and handbooks. The following specifications, standards,
and handbooks form a part of this document to the extent specified herein. Unless otherwise
specified, the issues of these documents are those listed in the issue of the Department of Defense
Index of Specifications and Standards (DODISS) and supplement thereto, cited in the solicitation
(see 6.2).
Beneficial comments (recommendations, additions, deletions, clarifications) and any
pertinent data which may be of use in improving this document should be addressed to:
Defense Supply Center Philadelphia, Clothing and Textiles Directorate, Attn: DSCP-CNR,
700 Robbins Ave., Philadelphia, PA 19111-5096 by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 8340
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business