MIL-DTL-44400A
TABLE II. End item dimensional defects
Classification
Examine
Defect
Major
Minor
A
B
Overall
Smaller than specified dimensions
dimensions of less applicable minus tolerances
roof cap,
indicated on drawings
101
window wall Larger than specified dimensions
entranceway and applicable plus tolerance
wall, plain wall indicated on drawings
301
liners, floors or
rain gutters
Overall
Smaller than specified dimensions
dimensions of less applicable minus tolerances
transport bag- indicated on drawings but not
frame, trans- smaller than specified dimensions
port bag fabric less twice applicable minus tolerance
302
tent pin con- Smaller than specified dimensions
tainer or
less twice the applicable minus tolerance
support straps indicated on drawing
201
Larger than specified dimensions
and applicable plus tolerance indicated on drawing
303
Location
Not within specified tolerance:
Dimensions - Not exceeding twice the applicable tolerance
304
(unless other- - Exceeding twice the applicable tolerance
202
wise specified)
Webbing
Finished length less than specified by more than 1 inch
305
(tie-tapes)
Grommets
Set beyond specified location by more than ½ inch
203
Rope
Eye on footstop or line less than specified by
components, more than ½ inch
306
tent lines
Finished length of guy line less than specified:
- by not more than 4 inches
307
- by more than 4 inches but non more than 12 inches
204
- by more than 12 inches
102
Hems
Required to finish less than ¾ inch
or less in width, less than specified
205
Reinforce-
Finished dimensions less than specified by
ments
more than ½ inch
206
Ventilator
Misplaced by more than ½ inch
207
Opening
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business