MIL-DTL-1716J
3.6 Workmanship. Components shall be free from split, puncture, burr, rough or sharp edge,
malformation, deformation, or fracture. The completely finished pole shall be capable of
function without the use of tools.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. When a first article is required (see 6.2), it shall be examined for
defects specified in table III and 4.3.3.2. The presence of any defect shall be cause for
rejection of the first article.
4.3 Conformance inspection. Unless otherwise specified, sampling for inspection shall be
performed in accordance with ANSI/ASQC Z1.4.
4.3.1 Component and material inspection. Components and materials shall be inspected in
accordance with all the requirements of referenced specifications, drawings, and standards
unless otherwise excluded, amended, modified, or qualified, in this specification or applicable
purchase document. In addition to the quality assurance provisions of the subsidiary
specifications and drawings, testing shall be performed on components listed in table I for the
test characteristics shown. A lot shall consist of all bodies of locks (or locks when alternate
construction is used) offered for inspection at one time prior to stress relieving and plating.
The sample unit shall be one body of the lock (or lock when alternate construction is used).
TABLE I. Component test
Specification reference
Requirement Test method Requirements
Number
Results reported as
applicable to
determinations
Component Characteristic
Individual unit
per unit
Body of
Hardness
3.3.4.1 or
4.4
X
3
Average of three
lock
Rockwell
3.3.5 as
determinations to
C40-C45
applicable
nearest Rockwell
scale reading
4.3.2 In-process examination. Examination shall be made at any point during any phase of
the manufacturing for the requirements specified in table II to establish that no deviation is
made from the indicated requirements. Whenever a nonconformance is noted, correction
shall be made to affected items and process.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business