MIL-DTL-43492D
TABLE I. Defects (continued)
Classification
Examine
Defect
Major
Minor
A
B
secure closure
124
Thong omitted
338
Stovepipe
Set to roof with oval opening in a horizontal
shield
instead of vertical position
125
Exposed stitching or needle holes
339
Cementing,
Puckers, loose edges, unadhered pocket
general
or tunnels
235
Excess adhesion resulting in sags or
lumps evident through outer layer of fabric
236
Adhesive exposed beyond the overcoated
area on interior surface
340
General
Any other construction detail not performed
as specified
237
Marking &
labels
Omitted, incorrect, illegible, or misplaced
341
Cleanness
Grease or oil stains
342
Thread ends not trimmed to ½ inch or less
(except in slide fastener area)
343
Thread ends not trimmed to ½ inch or less
in slide fastener area
238
4.4.4 End item dimensional examination. The end item shall be examined for the defects listed
in Table II. The lot size shall be expressed in units of completely fabricated end sections, intermediate
sections, tent covers or frame carrying covers, as applicable. The sample unit shall be one end section,
intermediate section, tent cover or frame carrying cover, as applicable. The inspection level shall be S-3.
TABLE II. End item dimensional defects
Classification
Examine
Defect
Major
Minor
A
B
Overall dim- Smaller than specified dimensions less applicable
ensions of end minus tolerances indicated on drawings
101
sections &
frame
Larger than specified dimensions and applicable
carrying
plus tolerances indicated on drawings
301
covers
Covers,
Smaller than specified dimensions less applicable
tent
minus tolerance indicated on drawing but not
smaller than the specified dimensions less
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business