MIL-DTL-43492D
TABLE II. End item dimensional defects (continued)
Classification
Examine
Defect
Major
Minor
A
B
twice the applicable minus tolerance
302
Smaller than specified dimensions less twice the
applicable minus tolerances indicated on
drawing
201
Larger than specified dimensions and applicable
plus tolerances indicated on drawings
303
Location
Not within specified tolerance:
dimensions
- not exceeding twice the applicable
(unless other-
tolerance
304
wise
- exceeding twice the applicable
specified)
tolerance
202
Webbing,
Finished length less than specified by
tie tapes
more than 1 inch
305
Grommets
Set beyond specified location by more than
½ inch
306
Rope com-
Eye on footstop or line less than specified by
ponents;
more than ½ inch
203
tent lines
Finished length of guy line less than
specified:
- by not more than 4 inches
307
- by more than 4 inches but not more
than 12 inches
204
- by more than 12 inches
102
Beckets
Misplaced:
- by more than ¼ inch but not more
than ½ inch
308
- by more than ½ inch
205
Length of loop more or less than specified by
½ inch or more
206
Hems
Hems required to finish less than ¾ inch in width,
less than specified; hems required to finish more
than ¾ inch in width, less than specified by
more than ¼ inch
103
Reinforce-
Finished dimension less than specified by
ments
more than ½ inch
309
Any spliced piece less than 24 inches
in length
310
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business