MIL-DTL-10035L
For stitching on cover indi-
- Size FF for needle,
cated by "Z" on drawing
size F for looper
3.2.9 Lines, tent. The tent lines shall conform to class D or class G of MIL-L-1709 in the types
specified on the applicable drawings.
3.2.10 Stiffener, cord. The cord for the drip cap stiffener shall conform to type I, class 3, size No. 7 of
T-C-571.
3.2.11 Toggle loops. The cord for the toggle loops shall conform to polyester, 1/8 inch diameter,
Camouflage Green 483 of MIL-C- 43256.
3.2.12 Toggles, wood. The wood toggles shall be of the design and dimensions shown on Drawing 5-
4-225. The wood for the toggles shall be straight-grained, sound and smooth lumber, kiln dried to not
more than 15 percent moisture content when tested as specified in 4.3.1.1. The toggles shall be free
from knots, shakes, checks, splits, or splintery surface. Any of the following woods may be used:
Hickory
Beech
Pecan
Maple, hard
Red or White Oak
Birch
Rock Elm
Ash
3.2.13 Toggles, metal. The metal toggles shall be of the design and dimensions shown on Drawing 5-
4-223 and shall be fabricated from copper alloy wire conforming to alloy number 270, half hard temper
in accordance with ASTM-B134, 159, 159M, 206 and 206M. The toggles shall be given a black
chemical finish conforming to MIL-F-495.
3.2.14 Slip, tent line. The tent line slips shall conform to type II of MIL-S-1734.
3.2.15 Fasteners, slide, interlocking. The slide fasteners shall conform to type III, style I, size H, wire
stirrup pulls of V-F-106. Slide fastener chain shall be fabricated of brass or polyester coil. The slider
for the brass chain shall be brass and the slider for the polyester coil shall be die cast zinc alloy. The
slide fastener tape shall be dyed to match Camouflage Green 483 and be water repellent and mildew-
resistant. (Tapes made of 100 percent polyester need not be tested for mildew resistance.) The color
of the tape after treatment will be considered acceptable. The tape shall show good fastness to
weathering. Alternatively, the slide fastener chain shall be polyester continuous monofilament in a ladder
or coil type configuration. Color of the chain shall be Camouflage Green 483 or natural finish brass and
the sliders shall be brass.
3.2.16 Ring dee. The dee ring shall conform to class 1 or 2, configuration K, size 1 inch by ¾ inch of
MIL-R-3390.
* 3.2.17 Ring, connecting. The connecting rings shall be of steel wire or cast malleable iron, black
enamel, phosphate treated, zinc plate finished, size 2 or 5 in accordance with
Drawing 4-1-206.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business