MIL-DTL-12354G
TABLE III. End item dimensional defects cont'd
Classification
Examine
Defect
Major
Minor
A
B
Snow cloths
Less than specified width by more
than 1 inch
315
Doorway flaps
Bottom end of flap uneven with
breakline of wall by more than
1/4 inch; outer edge or end of
facing uneven with edge or end
of flap by more than 1/4 inch
316
Peak of wall
Peak of wall halves joined to
roof with edges of door opening
less than 7/8 inch apart,
failing to provide clearance
for top of slide fastener
208
Ventilator opening
Misplaced:
- by more than 1/2 inch
317
Stovepipe opening
Misplaced:
- by more than 1/2 inch
318
Ring, ring chapes,
Misplaced:
straps and strap
- by more than ¼ inch but
reinforcement
not more than 1/2 inch
319
- by more than 1/2 inch
209
Cover flaps
Center line of flaps set off
center of body more than
3/4 inch
320
4.4.5 End item testing. The completely fabricated tents with covers shall be tested as specified in 4.5.1
for conformance to the wicking requirements specified in 3.3.11. The lot size shall be expressed in units
of tents. The sample size shall be the number of tents indicated by inspection level S-3. Any test failure
shall be cause for rejection of the lot.
4.4.6 Packaging examination. The fully packaged end items shall be examined for the defects listed
below. The lot size shall be expressed in units of shipping containers. The sample unit shall be one
shipping container fully packaged. The inspection level shall be S-2.
25
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business