MIL-DTL-12354G
3.2.14 Fasteners, slide interlocking. The slide fasteners shall conform to type III, style 1, size H, wire
stirrup pulls of V-F-106. Slide fastener chain shall be fabricated of brass or polyester coil. The slider for
the brass chain shall be brass and the slider for the polyester coil shall be die cast zinc alloy. The slide
fastener tape shall be dyed to match CG 483 and be water repellent and mildew resistant. (Tapes made of
100 percent polyester need not be tested for mildew resistance.) The color of the tape after treatment will
be considered acceptable. The tape shall show good fastness to weathering. Alternatively, the slide
fastener chain shall be polyester continuous monofilament in a ladder or coil type configuration. Color of
the chain shall be CG 483 or natural finish brass and the sliders shall be brass.
3.2.15 Rings, dee. The dee rings shall conform to class 1 or 2, configuration K, 1 inch by ¾ inch of MIL-
R-3390.
*3.2.16 Ring, connecting. The connecting rings shall be of steel wire or cast malleable iron, black enamel,
phosphate treated, zinc plate finished, size 2 or 5 in accordance with
Drawing 4-1-206.
*3.2.16.1 Steel wire. The steel wire shall conform to steel numbers 1006 to 1020 in accordance with
ASTM A853, ASTM A818, ASTM A641 or ASTM A809.
*3.2.16.2 Steel tube. The steel tube shall be seamless, round in accordance with ASTM A513 and
ASTM 519.
*3.2.16.3 Malleable iron. The malleable iron shall be grade I (35018)-Black, ungalvanized or grade II
(32510)-Black, ungalvanized in accordance with ASTM A47. The first three digits of the grade
designations indicate the minimum yield strength ( x 100 p.s.i.). The last two digits indicate the minimum
elongation (percent in 2 inches).
3.2.17 Plate, peak. The peak plate shall conform to type XVIII of MIL-P-500.
*3.2.18 Snaphooks. The snaphooks shall conform to NASM 43770/10.
*3.2.19 Grommets, metallic. The grommets shall conform to type III, class 3 of NASM 16491 in the
following sizes:
No. 1 (for connecting lug becket cord)
No. 2 (for footstops, type "B")
No. 4 (for footstops, type "A")
3.2.20 Fasteners, snap. The snap fasteners shall conform to style 2, finish 2, button 24 line size,
size 1 and eyelet size 1 of MIL-F-10884.
3.2.21 Clip, end strap. The end clips shall conform to type I, class 1 or 2, size 1 inch of
MIL-C-496.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business