MIL-DTL-43695C
4.4.1 Component and material inspection. In accordance with 4.1, components and
materials shall be inspected in accordance with all the requirements of referenced documents
unless otherwise excluded, amended, modified or qualified in this specification or applicable
purchase document.
4.4.2 In-process inspection. Inspection shall be made of the operations and requirements
listed in Table I to establish conformance with the specified requirements. Whenever
nonconformance is noted, correction shall be made to the items affected and the operations.
Table I. In-process inspection.
------------------------------------------------------------------------------------------------------------------
Requirement or operation
Requirement paragraph
------------------------------------------------------------------------------------------------------------------
Welds are sound, smooth, uniform and free
from burn through area, pits, slag
inclusion porosity, crack, fracture
flash and excess flux deposit.
3.5.1 and 3.8
Castings are clean and free from pits,
blowholes, flashing and scale
3.5.3
All completely fabricated metal components are
clean and exterior surfaces of aluminum are treated
prior to assembly.
3.6.1
Exterior surfaces of metal components including
chains, rings, screws, plus both sides of steel
eave and ridge gusset plates and header end
plates (except shaft of quick release pin)
are primed before assembly.
3.6.2
Enamel is not applied before the primer has dried.
3.6.3
------------------------------------------------------------------------------------------------------------------
*4.4.3 End item visual examination. The end item shall be examined for the defects listed
in Table II. The lot size shall be expressed in units of frame sections of one type only. The
sample unit shall be one completely fabricated frame section. The inspection level shall be I.
TABLE II. Classification of defects
Classification
Examine
Defect
Major
Minor
Finish
Color of finish is not as specified
201
Not finished (except shaft of quick release pin)
101
Shaft of quick release pin has been coated with
primer or enamel
202
Not continuous or uniform (e.g., sag, pinhole,
Blister, wrinkle, foreign matter imbedded in
finish, wet or tacky finish
203
Any run exceeding 3 inches in length
102
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business